Bronze Fitted Cast Iron Construction. Close Coupled to a 10 Horsepower, 3450 RPM, 230/460 Volts, 3 Phase Motor. Ports are 2 Inches NPT Inlet, 2 Inches NPT Outlet. Impeller Diameter is 6.25 Inches.

Currently In Stock (Availability Subject to Change - Inventory Fluctuates Daily)

SKU: 3100WG6-2 Categories: , Tags: ,


3100WG6-2 Burks Pump

3100WG6-2 Self Priming Pump – Centrifugal

All WG6 General Info
  • Casing is close grain iron of 30,000 psi minimum tensile strength. Another feature is the back pull-out design eliminates the need to disturb piping should the pump ever require service – the casing stays in the line.
  • Enclosed Bronze Impeller is of the latest hydraulic design while maintaining maximum efficiency. It is balanced as a result for vibration-free operation. It is precision fit to shaft with key drive and cap screw lock.
  • Mechanical Shaft Seal. Standard self-adjusting shaft seal for temperatures up to 225°F (107 °C) and pressures to 150 psi (1034 kpa). Ceramic seat and carbon seal face for long trouble-free service. Special seals are also available for higher temperatures and fluids other than water.
  • JM Type motors have NEMA standard mounting flange, in addition to extended steel shaft and dual bearings. These motors also offer the advantage of quiet operation, controlled shaft deflection for longer seal life, and bearings sized to provide good service life. All motors are supplied by manufactures with national field service facilities.
  • Flapper and check valves on the suction pipe are not required, but are recommended.
  • Bronze Shaft Sleeve. Gasketed and keyed hook-type sleeve protects shaft from wear and corrosion in seal area.
  • Factory tested. After careful assembly and inspection, EVERY pump is factory tested and will meet Hydraulic Institute standards.
Motor Information
  • 60 Hz – 3500 RPM – ODP Enclosure
    • Three Phase: 5 HP, 7 1/2 HP & 10 HP – 230/460 Volt

Please note, voltages may differ as a result from supplier to supplier. In conclusion Call us today to confirm any specification.

Overload Protection

All motors must be installed with a magnetic starter which provides full 3-leg protection. Failure to use correct starter and overloads as a result, will void motor warranty.

Maximum Operating Conditions
  • Temperature (For Standard Buna-N Seal) – 225 ºF (107 ºC)
  • Inlet Pressure – 100 PSI (689 kPa)
  • Casing Working Pressure – 200 PSI (1379 kPa)

3100WG6-2 Burks Pump

Additional information

Attribute Information
Weight 175 lbs

Product Inquiry

Your Name: First & Last (required)

Your Email (required)

Company Name




Zip Code

Phone Number


Shipping Collect Account

(Pump Image / Nameplate / Tax Exempt Documents)

Your Message